Can I replace an electric oven with a gas hob by plugging it into the existing plugs?

View All Categories
  • Lauren's Avatar
    Community Manager
    Question: Previous owners of my property left built-in electric oven with a gas hob - both are wired directly into the mains. The oven and hob I have picked as a replacement both have cable with a plug attached. Will they be able to be installed without too much hassle?
    Last edited by Lauren; 25-10-21 at 10:45.
  • 3 Replies

  • Sparky uk's Avatar
    Level 1
    The question is a simple one, however the answer isn’t.
    if the manufacturer has fitted a 13amp 3 pin plug then the loading is less than 13amps for the oven.

    And the ignition for the gas hod has a manufacturer’s factory fitted 3 pin plug then it only takes 1 to 3 amps.

    So knowing the loading we can look at the fuse board and see if the cooker fuse/MCB is over these values then you should be fine, if you are plugging them into the existing socket.

    However, we are assuming that the socket you are plugging them into is Fit for purpose. As we can’t assume anything, it needs to be tested and inspected to make sure it’s compliant with the rewiring regulations BS 7671.
    If you’ve had your property inspected and tested on regular basis then you should be ok, if you haven’t then I would suggest that you have a domestic electrical installation condition report conducted.

    You also need to read the manufacturers instructions for installation.

    You can’t work on the Gas supply : connection to your hob or electrical circuits unless you are a Qualified and registered.

    Sorry for a long answer to a simple question.
  • Lauren's Avatar
    Community Manager
    Morning @Sparky uk

    I hope you are well! Thank you so much for taking the time to answer this - 😊
    Last edited by Lauren; 25-10-21 at 10:45.
  • SEL's Avatar
    Level 1
    sparky uk made a clear point to be honest can not add anything else because they mentioned everything needed to be done. well done sparky uk👍